Search 
please enter your... :attiny31

PIC16F627

Peripheral Features:
• 15 I/O pins with individual direction control
• High current sink/source for direct LED drive
• Analog comparator module with:
   - Two analog comparators
   - Programmable on-chip voltage reference(VREF) module
   - Programmable input multiplexing from device inputs and internal voltage reference
   - Comparator outputs are externally accessible
• Timer0: 8-bit timer/counter with 8-bit programmable prescaler
• Timer1: 16-bit timer/counter with external crystal/clock capability
• Timer2: 8-bit timer/counter with 8-bit period register,prescaler and postscaler
• Capture, Compare, PWM (CCP) module
   - Capture is 16-bit, max. resolution is 12.5 ns
   - Compare is 16-bit, max. resolution is 200 ns
   - PWM max. resolution is 10-bit
• Universal Synchronous/Asynchronous Receiver/Transmitter USART/SCI
• 16 Bytes of common RAM
Special Microcontroller Features:
• Power-on Reset (POR)
• Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
• Brown-out Detect (BOD)
• Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
• Multiplexed MCLR-pin
• Programmable weak pull-ups on PORTB
• Programmable code protection
• Low voltage programming
• Power saving SLEEP mode
• Selectable oscillator options
   - FLASH configuration bits for oscillator options
   - ER (External Resistor) oscillator
   - Reduced part count
   - Dual speed INTRC
   - Lower current consumption
   - EC External Clock input
   - XT oscillator mode
   - HS oscillator mode
   - LP oscillator mode
• Serial in-circuit programming (via two pins)
• Four user programmable ID locations CMOS Technology:
• Low-power, high-speed CMOS FLASH technology
• Fully static design
• Wide operating voltage range
   - PIC16F627 - 3.0V to 5.5V
   - PIC16F628 - 3.0V to 5.5V
   - PIC16LF627 - 2.0V to 5.5V
   - PIC16LF628 - 2.0V to 5.5V
• Commercial, industrial and extended temperature range
• Low power consumption
  - < 2.0 mA @ 5.0V, 4.0 MHz
  - 15 mA typical @ 3.0V, 32 kHz
  - < 1.0 mA typical standby current @ 3.0V